Filter
Top Products
Appendix 2 - 13
MDS-D-SVJ3/SPJ3 Series Instruction Manual
Appendix 2-2 CM10-APxxS-x(D6) angle plug connector
(6) Inserting the contact
Insert the contact into the specified terminal number point in the housing.
(Insert grounding wire or drain wire into terminal No. 10)
* When the contact catches the housing, you will hear a snap.
* Pulling the wire for confirming the correct position.
(Note) Before inserting the contact, check that the clamp nut, cable clamp, bushing and angle back
shell is inserted.
Take care not to insert the contact upside down as shown below.
* Insert the contact so that the
terminal number face the same
direction.
However, in case of CM10-AP2S-
x(D6), insert the contact so that the
lance and the terminal number face
the opposite direction.
* Using a pull out tool for pulling up
inserted contact.
Tool No.: 357J-50548T
Refer to the instruction manual in
case of using pull up tool.
* As Lance falls down easily after
pulling up, set up to original position
before re-insert.
Cable
Housing
Contact
Insert
Terminal No.10 only
(Grounding wire or drain wire)
Terminal number
Terminal number
Lance
Lance
Contact
Contact
CM10-AP2S
CM10-AP10S