Filter
Top Products
Date of revision Manual No.
Revision details
Jan. 2011 IB(NA)1500193-C
- "Synchronous tapping adjustment (For machining system)" was changed to
"Synchronous tapping adjustment" and revised.
- "Spindle C axis adjustment (For lathe system)" was revised.
- "High-response acceleration/deceleration function" and "Spindle cutting
withstand level improvement" were added.
- "List of alarms", "List of warnings" and "Troubleshooting" were revised.
- "Cable and Connector Specifications" was revised.
- "Compliance to EC Directives" was revised.
- "EMC Installation Guidelines" was revised.
- "EC Declaration of Conformity" was revised.
- "Global service network" was revised.
- Miswrite is corrected.
Sep. 2011 IB(NA)1500193-D
- Descriptions related to the unit type followed by "NA" were added. (SVJ3-
10NA/20NA, SPJ3-22NA: The connector for CNP1,2 and 3 was changed.)
- "Precautions for safety" was revised.
- "Handling of our product" was added.
- Function specifications list was revised.
- A caution was added to "Shaft characteristics" in "Installation of tool spindle
motor".
- "Spindle side detector" was replaced by "Spindle side ABZ pulse output
detector".
- "Spindle side accuracy detector" was replaced by "Spindle side PLG serial
output detector".
- "Installation accuracy diagnosis for PLG detector" was revised.
- "Connecting with optical communication repeater unit" was added.
- "Motor and detector connection", "Wiring of the peripheral control", "Wiring of
the motor magnetic brake (MDS-D-SVJ3)", "Wiring of an external emergency
stop", "Safety observation function" were revised.
- "Setting of machine side detector" was revised.
- List of parameters were revised.
- "Position loop gain", "Characteristics improvement" and "Settings for
emergency stop" in "Servo Adjustment" were revised.
- " Adjustment procedures for each control" was revised.
- "Settings for emergency stop" was added to "Spindle Adjustment".
- "List of alarms" and "Troubleshooting for each alarm No." were revised.
- "Cleaning of spindle motor" was added.
- "MDS-BTBOX-36" was added.
- "Cable and Connector Specifications" was revised.
- "Cable and Connector Assembly" was revised.
- "Precautions in Installing Spindle Motor" was revised.
- "EC Declaration of Conformity" was revised.
- "Global service network" was revised.
- Miswrite is corrected.