Filter
Top Products
MDS-D-SVJ3/SPJ3 Series Instruction Manual
2-2 Main circuit terminal block/control circuit connector
2 - 13
(3) MDS-D-SVJ3-35NA, MDS-D-SPJ3-37NA
(a) Drive unit power supply connectors
(b) Termination of the cables
[1] CNP1, CNP3
Solid wire: After the sheath has been stripped, the cable can be used as it is.
Twisted wire: Use the cable after stripping the sheath and not twisting the core. At this time, take
care to avoid a short caused by the loose wires of the core and the adjacent pole.
Do not solder the core as it may cause a contact fault. Alternatively, a bar terminal
may be used to put the wires together.
[2] CNP2
CNP2 is the same as MDS-D-SVJ3-03NA/04NA/07NA or MDS-D-SPJ3-075NA. Refer to (1) (b) in
this section.
Cable size Bar terminal type
Crimping tool Manufacturer
[mm
2
]
AWG For 1 cable For 2 cables
0.34 22 AI0.34-8TQ -
CRIMPFOX-ZA3 Phoenix Contact
0.5 20 AI0.5-8WH AI-TWIN2×0.5-8WH
0.75 18 AI0.75-8GY AI-TWIN2×0.75-8GY
1 18 AI1-8RD AI-TWIN2×1-8RD
1.5 16 AI1.5-8BK AI-TWIN2×1.5-8BK
2.5 14 AI2.5-8BU AI-TWIN2×2.5-10BU
CNP3
CNP1
CNP2
PC4/6-STF-7.62-CRWH
54927-0510(Molex)
PC4/3-STF-7.62-CRWH
Connector for CNP1
Phoenix Contact
Connector for CNP3
Phoenix Contact
Connector for CNP2
Ǿ
3.8mm
Ǿ
5mm
7mm
Core
Sheath