99
CHAPTER 6 VARIOUS SETTINGS
6
6.1 Adding a Module
CHAPTER 6 VARIOUS SETTINGS
This chapter describes setting procedures of the QD73A1.
● After writing the contents of the new module, parameter settings, and auto refresh settings into the CPU module, reset
the CPU module and switch its status as STOP RUNSTOP RUN, or turn off and on the power supply to activate
the settings.
● After writing the contents of the switch settings, reset the CPU module or turn off and on the power supply to activate the
settings.
6.1 Adding a Module
(1) Addition procedure
Open the "New Module" window.
Project window [Intelligent Function Module] Right-click [New Module...]
Item Description
Module
Selection
Module Type Set "QD70 Type Positioning Module".
Module Name Set the name of the module to mount.
Mount
Position
Base No. Set the base unit where the module is mounted.
Mounted Slot No. Set the slot No. where the module is mounted.
Specify start XY
address
The start I/O number (hexadecimal) of the module is set, according to the mounted
slot No. Any start I/O number can be set.
Title setting Title Set any title.