80
(3) Creep speed
Once the near-point dog turns on, the control decelerates from " OPR speed" and stops. Set the speed of
right before the stop, which is a creep speed.
Satisfy the following condition when setting the speed.
Creep speed OPR speed Speed limit value
If the creep speed exceeds " OPR speed", the error "Creep speed Outside the setting range" (error code:
21) occurs, and the OPR is not executed.
Pr.12
Pr.11
OPR speed
OPR start
Creep speed
Zero signal
OFF
ON
v
t
Pr.11
Pr.12
Near-point
dog signal
(DOG)
Pr.12
Pr.11
Pr.5
Pr.11