Filter
Top Products
36
(23)Zero/gain adjustment change complete flag (X2B)
This signal turns on when zero adjustment and gain adjustment were switched after Zero/gain adjustment
change request signal (Y1B) was turned on.
When Zero/gain adjustment change request signal (Y1B) is turned off, this signal turns off.
Use this signal as an interlock condition to turn on/off Zero/gain adjustment change request signal (Y1B) when
changing " Zero/gain adjustment specification".
For details on zero/gain adjustment, refer to the following.
Page 59, Section 4.5
(24)Set value change complete flag (X2C)
This signal turns on when the analog output value of zero/gain adjustment was changed after Set value change
request signal (Y1C) was turned on.
When Set value change request signal (Y1C) is turned off, this signal turns off.
Use this signal as an interlock condition to turn on/off Set value change request signal (Y1C) when performing
zero/gain adjustment.
For details on zero/gain adjustment, refer to the following.
Page 59, Section 4.5
(25)Operating status of the speed-position control switch mode (X2D)
This signal indicates the operating status in the speed-position control switch mode.
This signal is on during speed control.
This signal is off during position control.
Zero/gain adjustment change
complete flag (X2B)
Zero/gain adjustment change
request signal (Y1B)
OFF
ON
OFF
ON
Zero/gain adjustment
specification
Executed in a sequence program
Executed by the QD73A1
Cd.10
Cd.10
Set value change complete flag
(X2C)
Set value change request signal
(Y1C)
OFF
ON
OFF
ON
Executed by the QD73A1
Executed in a sequence program