Mitsubishi Electronics QD73A1 Universal Remote User Manual


 
240
13.4 Error Clear Function
When an error occurs, the error can be cleared on the system monitor.
By clicking the button in the system monitor, the error codes stored in " Error code (ERR.1)" and
" Error code (ERR.2)" are cleared, and the ERR. LED turns off. This operation is the same as the one that uses
Error reset signal (Y28).
However, the error history cannot be cleared with the button.
For the error clearing method using Error reset signal (Y28), refer to the following.
Page 38, Section 3.4.3 (12)
[Diagnostics] [System Monitor...] Error module
Md.3
Md.4