Mitsubishi Electronics QD73A1 Universal Remote User Manual


 
126
(c) Device used by the user
(d) Program example
*1 Positioning data can be set through GX Works2 also. ( Page 109, Section 6.4)
The sequence program that sets positioning data is unnecessary when the data were set through GX Works2.
Device Description
X33 Positioning data write command
X34 Positioning start command
D30 Positioning pattern
D31 Positioning address P1 (lower 16 bits)
D32 Positioning address P1 (upper 16 bits)
D33 Positioning speed V1 (lower 16 bits)
D34 Positioning speed V1 (upper 16 bits)
M40 Positioning start command pulse
Positioning pattern (Positioning control)
Positioning address P1 (100000pulse)
Positioning speed V1 (10000pulse/s)
Set positioning data to the QD73A1.
Command the positioning start.
Turn on Absolute positioning start signal.
Turn off Absolute positioning start signal.
*1