Mitsubishi Electronics QD73A1 Universal Remote User Manual


 
268
All the other specifications are the same.
LED
RUN None
ERR. ERR.1/ERR.2 (Minor/major error)
ZERO None
GAIN None
None (check with X signal) SV RDY (Servo READY signal)
None (check with X signal) DOG (Near-point dog signal)
None (check with X signal) STOP (Stop signal)
None (check with X signal) FLS (Upper limit signal)
None (check with X signal) RLS (Lower limit signal)
None (check with X signal) IN-POS. (In-position)
None (check in the buffer memory) POLE (Deviation counter polarity)
None (check in the buffer memory)
2
N
(Deviation counter value)
None (check with Y signal) PC RDY (PLC READY signal)
None (check with X signal) ZERO (OPR request signal)
None (check with X signal) EEX (Excessive error)
None (check with X signal) WDT ERR. (Hardware error)
None (check with X signal) V-MODE (Operating status)
Zero/gain adjustment
• Adjustment using the UP/DOWN switch
• Adjustment using the buffer memory
Adjustment using volumes
Mode switch Intelligent function module switch DIP switch
Item
Specifications
QD73A1 AD70 A1SD70