Filter
Top Products
275
APPENDICES
A
Appendix 4 When Using GX Developer
Appendix 4.1 Operation of GX Developer
Appendix 4 When Using GX Developer
This section describes the operating procedure of GX Developer.
When using GX Developer, configure the parameter settings and the auto refresh settings with the sequence program.
• PROGRAMMING ( Page 111, CHAPTER 7)
(1) Applicable software versions
For applicable software versions, refer to the following.
Page 22, Section 2.1 (4)
Appendix 4.1 Operation of GX Developer
Configure the following settings when using GX Developer.
(1) I/O assignment
Configure the setting on "I/O assignment" in "PLC parameter".
Parameter [PLC parameter] [I/O assignment]
Window name Application Reference
I/O assignment
Set the type of the module to be mounted and the I/O signal
range.
Page 275, Appendix 4 (1)
Intelligent function module
switch setting
Configure the switch setting of the intelligent function
module.
Page 276, Appendix 4 (2)
Item Description
Type Select "Intelli.".
Model name Enter the model name of the module.
Points
The QD73A1 uses two slots. Select "Empty" and "0point" or "16points" for the first slot. Select "Intelli."
and "32points" for the second slot.
StartXY Enter any start I/O number of the QD73A1.