Filter
Top Products
146
3. Display the QD73A1's switch setting window, and configure the setting as follows.
Project window [Intelligent Function Module] [QD73A1] [Switch Setting]
4. Write the set parameters to the remote I/O module, then reset the remote I/O module.
[Online] [Write to PLC...]
Item Setting value
Rotation direction setting Set this item according to the system to be used.
Accumulated pulse setting Set this item according to the system to be used.
Multiplication setting Set this item according to the system to be used.
OPR direction setting Set this item according to the system to be used.
OPR method setting Set the near-point dog method or the count method.
Encoder I/F setting Set this item according to the system to be used.
Analog voltage resolution setting Set this item according to the system to be used.
Feed back pulse addition/subtraction setting Set this item according to the system to be used.
Deviation counter clear setting Set this item according to the system to be used.
Zero/gain adjustment mode/Normal mode setting Set "Normal mode".
MODE
RESET
Press the switch
in this direction
for a while.