Filter
Top Products
4 - 9
MELSEC-
A
4 INSTALLATION, WIRING AND MAINTENANCE OF THE PRODUCT
4.2.2 Installation/removal of module
This section explains the procedures for installing and removing the D75P2.
[1] Installation (removal) to (from) DIN rail
Installation procedure
(1) Confirm if all phases of the externally supplied power for the system are switched
off or not.
*If not, switch off all phases.
(2) Match the DIN rail groove in the module bottom with the top of the DIN rail.
(3) Press the module against the DIN rail, and fix it there.
Module installation method
DIN rail
Module
(4) Confirm that the module is fixed to the DIN rail.
[After-work checks]
After installing the module, check the work as in the following list.
Check the module for looseness.
Check the DIN rail for looseness.