Filter
Top Products
4 - 21
MELSEC-
A
4 INSTALLATION, WIRING AND MAINTENANCE OF THE PRODUCT
(2) Connecting the connector and wire
* Refer to section "3.7 Specifications of input/output interfaces with external
devices" when connecting.
(a) Loosen the cable fixture screw B, pass the cable through,
and then tighten screw B.
(Screw B may be removed once, and then tightened after sandwiching the
cable.)
(Take care not to lose the screw and nut.)
B
Pass the cable through
Cable fixture
Connector
(b) Solder the wire onto the connector.
Connector pin layout
19
20
2
17
35
36
18
1
Solder
Wire
* The applicable size of the wire to be connected is approx. 0.05 to
0.2mm
2
(30 to 24 AWG).