A - 18
USING THIS MANUAL (2)
The methods for reading this manual are shown below.
5.1 Types of data
5.2 List of parameters
5.3 List of positioning data
5.4 List of start block data
5.5 List of condition data
5.6 List of monitor data
5.7 List of control data
Chapter 7
MEMORY CONFIGURATION
AND DATA PROCESS
Chapter 6
SEQUENCE PROGRAM USED
FOR POSITIONING CONTROL
Chapter 14 TROUBLESHOOTING
Chapter 13
COMMON FUNCTIONS
SECTION 1 PRODUCT SPECIFICATIONS AND HANDLING
Chapter 1 PRODUCT OUTLINE
Chapter 2 SYSTEM CONFIGURATION
Chapter 3 SPECIFICATIONS AND
FUNCTIONS
Chapter 4 INSTALLATION, WIRING
AND MAINTENANCE OF
THE PRODUCT
Chapter 5 DATA USED FOR
POSITIONING CONTROL
SECTION 2 CONTROL DETAILS AND SETTING
Chapter 8 ZERO POINT RETURN
CONTROL
Chapter 9 MAIN POSITIONING
CONTROL
Chapter 10
ADVANCED
POSITIONING CONTROL
Chapter 11 MANUAL CONTROL
Chapter 12 CONTROL AUXILIARY
FUNCTIONS
*
Understand the data process in the D75P2 as necessary.
6) Remedies for "Errors" and "Warnings"
5) Create a sequence program for control
4) While referring to lists in "SECTION 2" and "Chapter 5",
set the data required for each control
3) Set the parameters
2) Install and wire the product
1)
2)
3)
4)
5)
Test operation
6)
Actual operation
1) Understand the product functions and specifications,
and design the system.