Filter
Top Products
14 - 33
MELSEC-
A
14 TROUBLESHOOTING
Relevant buffer memory address
remote input/output device, or remote
register
Setting range Remedy
Axis 1 Axis 2
74
75
224
225
(In standard mode)
1 to 1000000 [pulse/s]
1 to 600000000 [mm/min, etc.]
(In stepping motor mode)
1 to 62500 [pulse/s]
1 to 37500000 [mm/min, etc.]
Change the setting to within the setting range and turn
OFF then ON the remote station READY signal
[RX(n+7)B].
76
77
226
227
(In standard mode)
1 to 1000000 [pulse/s]
1 to 600000000 [mm/min, etc.]
(In stepping motor mode)
1 to 62500 [pulse/s]
1 to 37500000 [mm/min, etc.]
78 228 0, 1
86 236 1 to 300
80
81
230
231
(In standard mode)
0 to 2147483647
(In stepping motor mode)
0 to 134217727
82 232 0, 1, 2 ,3
83 233 0, 1, 2 ,3
88 238 0, 1
Write the flash ROM again.
If the same error persists, replace the module.