Filter
Top Products
4 - 14
MELSEC-
A
4 INSTALLATION, WIRING AND MAINTENANCE OF THE PRODUCT
4.4 Module setting
This section explains the setting of the D75P2.
4.4.1 Station number setting of module
Set the station number of the D75P2.
*The default value (factory setting) is station No. "01".
[1] Setting bases
1) The setting number should be within the range "01" to "61".
(The D75P2 occupies four stations, starting with the setting number.)
2) The setting number should be "any number that does not overlap with and is
continuous with the other station numbers".
* The station number can be set regardless of the device connection order.
* If No. "62" or more is set, the "L ERR" lamp of the "CC-Link status indicator LEDs"
will turn on at the time of data communication.
[2] Setting method
Insert a flat-blade screwdriver into the arrow-shaped groove, and turn it to the numeral
of the number to be set.
Turn the arrow to the numeral in the ten place of the number to be set.
Example) When station No. is 24, set the arrow to value "2".
Turn the arrow to the numeral in the one place of the number to be set.
Example) When station No. is 24, set the arrow to value "4".