Mitsubishi Electronics AJ65BT-D75P2-S3 Universal Remote User Manual


 
10 - 7
MELSEC-
A
10 ADVANCED POSITIONING CONTROL
10.3 Setting the start block data
10.3.1 Relation between various controls and start block data
The "start block data" must be set to carry out "advanced positioning control". The
setting requirements and details of each "start block data" item to be set differ
according to the "
Da.12 Special start command" setting.
The following shows the "start block data" setting items corresponding to various
control methods. The operation details of each control type are explained starting in
section 10.3.2. Also refer to section "10.4 Setting the condition data" for details on
"condition data" with which control execution is judged.
Advanced positioning
control
Start block data
setting items
Block
start
(Normal
start)
Condition
start
Wait start
Simulta-
neous
start
Stop
Repeated
start
(FOR loop)
Repeated
start
(FOR
condition)
NEXT
start *
Da.10
Shape
0 : End
1 : Continue
Da.11 Start data No. 1 to 600
Da.12
Special start command 0 1 2 3 4 5 6 7
Da.13 Parameter Condition data No.
No. of
repetitions
Condition
data No.
: One of the two setting items must be set.
: Set when required (Set to " – " when not used.)
: Setting not possible
: Setting not required (Setting value will be ignored. Use the initial value or a value within the setting range.)
* The "NEXT start" command is used in combination with "repeated start (FOR loop)" and "repeated start (FOR
condition)". Control using only the "NEXT start" will not be carried out.