Filter
Top Products
6 - 6
MELSEC-
A
6 SEQUENCE PROGRAM USED FOR POSITIONING CONTROL
[4] Initializing the master station
Create the following program to initialize (set the parameters, start the data link) the
master station.
Refer to section 6.1.1 for details on the program conditions.
(1) Set the No. of
connected modules
(2) Set the station
information
(3) Set the master
station buffer memory
Refresh indication
Start data link with buffer
memory
If normal, reset start
request signal
If error, read parameter state
Reset start request signal
(1) No. of connected modules ( M 1H)
Set the No. of remote I/O stations, remote device stations, intelligent device
stations and local stations connected to the master module. (Including the
reserved stations.)