Filter
Top Products
9 - 41
MELSEC-
A
9 MAIN POSITIONING CONTROL
(1) 2-axis circular interpolation control with center point designation
(ABS right arc, ABS left arc)
Operation chart
In the absolute system, 2-axis circular interpolation control with center point
designation, addresses established by a machine zero point return on a 2-axis
coordinate plane are used. Positioning is carried out from the current stop position
(start point address) to the address (end point address) set in "
Da.5
Positioning
address/movement amount", in an arc path having as its center the address (arc
address) of the center point set in "
Da.6
Arc address".
Radius
Movement by circular interpolation
Forward direction
Reverse direction
End point address
Start point address
(current stop position)
Arc address
Forward direction
Reverse direction
(positioning address)
Positioning of a complete round with a radius from the start point address to the
arc center point can be carried out by setting the end point address (positioning
address) to the same address as the start point address.
Arc center point
Reverse direction
Forward direction
(Arc address)
(current stop position)
Start point address
=
Reverse direction
Forward direction
End point address
(positioning address)