Filter
Top Products
DEFINITY ECS Release 8.2 Maintenance for R8.2csi
555-233-119 Issue 1
April 2000
Maintenance Objects
3-623DTMR-PT [Dual Tone Multifrequency Port (TTR)]
3
DTMR-PT [Dual Tone Multifrequency
Port (TTR)]
The Dual Tone Multifrequency Receiver Port (DTMR), also known as the
Touch-Tone Receiver (TTR), resides on the Tone Detector circuit pack (TN748,
TN420) or the TN756 Tone-Clock circuit pack. There are four Dual Tone
Multifrequency Receiver (DTMR-PT) ports and two General Purpose Tone
Detector (GPTD-PT) ports on a Tone Detector circuit pack. The DTMR port is
used to detect touch-tone digits that are placed on the TDM bus. Examples of
touch-tone digits are digits 0 through 9, #, and *. The ability of the DTMR port to
detect touch-tone digits is essential for maintenance of other circuit packs (for
example, Tone-Clock circuit pack) and in placing a station-to-station call. Calls
originating from a hybrid station
do not
require a DTMR port.
The Dual Tone Multifrequency Receiver Port maintenance object defines a set of
tests to verify that the DTMF digits detection capability of the DTMR port is
functioning properly. For all Tone Detector circuit pack level errors (DETR-BD),
refer to the XXX-BD (Common Port Circuit Pack) Maintenance documentation.
MO Name (in
Alarm Log)
Alarm
Level
Initial Command to
Run
1
1. Where P is the port network number (1 for PPN); C is the carrier designation (for example, A, B, or
C); SS is the address of the slot in the carrier where the circuit pack is located (for example, 01, 02,
..., etc.); and pp is the 2-digit port number (for example, 01).
Full Name of MO
DTMR-PT MAJOR test port PCSSpp sh Dual Tone Multifrequency Receiver
Port (TTR)
DTMR-PT MINOR test port PCSSpp sh Dual Tone Multifrequency Receiver
Port (TTR)
DTMR-PT WARNING release port PCSSpp Dual Tone Multifrequency Receiver
Port (TTR)