Filter
Top Products
DEFINITY ECS Release 8.2 Maintenance for R8.2csi
555-233-119 Issue 1
April 2000
Maintenance Objects
3-962PRI-CDR/SEC-CDR (PRI-CDR Link)
3
The data extension can be a PDM, MPDM, DTDM, or ADU. The PDM,
MPDM, and DTDM connect to a Digital Line Port of TN754 or TN754B
Digital Line circuit pack; ADU connects to a Data Line Port of TN726 Data
Link circuit pack.
NOTE:
In duplicated systems it is possible for a failure on one of the
processor circuit packs to bring down the CDR link even if it is the
standby processor. This problem can not be resolved by
interchanging processors because the CDR ports on each of the
processor circuit packs are connected via WIRE-OR.
CDR Link Maintenance does not cover the maintenance of the elements
composing the CDR physical link, which are as follows:
■ External CDR output device
■ EIA port on Processor circuit pack
■ Data Module (PDM/MPDM/DTDM) and Digital Line Port of TN754 or
TN754B Digital Line circuit pack
■ ADU and Data Line Port of TN726 Data Link circuit pack
■ Data Channels on the TN798 Processor circuit pack
If CDR Link Maintenance cannot restore the CDR link, then the maintenance tests
of these individual components of the CDR link must be executed to diagnose
faults.
Procedures for Restoring the CDR Link
1. Get the status of CDR links.
Enter
status cdr-link
command and make sure that the CDR links are not
busied out for maintenance. If the link is down, then continue to the next
step.
2. Where does the CDR link connect to?
Enter
display system feature
and find out the destinations of CDR links.
Continue to the next step.
3. Is the destination an extension or the EIA port?
If the destination is an extension number, then enter the
status data
extension
command and verify whether the data extension is in the
in-service/idle state. If the data extension is NOT available, then look for
the extension number in the
Alt Name
field of Hardware Error Log and
refer to ‘‘XXX-BD (Common Port Circuit Pack)’’
Maintenance
documentation for resolutions.