Filter
Top Products
DEFINITY ECS Release 8.2 Maintenance for R8.2csi
555-233-119 Issue 1
April 2000
Maintenance Objects
3-179ATM-EI (Expansion Interface Circuit Pack)
3
ATM Board Time Of Day Update (#1261)
This test is non-destructive. The ATM circuit pack requires a reference time to do
SDH/SONET performance monitoring. This test updates the system time to the
board and synchronizes the board with the DEFINITY system clock during
initialization, scheduled maintenance, and craft long test.
5 FAIL Unable to create loop for packet path for this test.
1. Retry the command at 1-minute intervals a maximum of 3 times.
2. If this test continues to fail, replace the ATM-EI circuit pack.
3. Test the new ATM-EI circuit pack (test board UUCSS long).
6 FAIL A previously-established looparound was not released.
1. Issue the reset board UUCSS command.
2. Retry the command at 1-minute intervals a maximum of 3 times.
3. If this test continues to fail, replace the ATM-EI circuit pack.
4. Test the new ATM-EI circuit pack (test board UUCSS long).
PASS The ATM-EI board is functioning properly, however this test does not
verify that the optical portion of the lightwave transceiver is functioning.
0NO
BOARD
No board was detected by the test.
1. Resolve either wrong board (Error 125) or no board (Error 131)
issues, if applicable.
2. Check that the board is properly translated and inserted. If so, check
for hyperactivity (Error 1538). If hyperactive, use the reset board
UUCSS command.
3. Run the test again. If it fails, the NCE chip on board may be bad.
Replace the board and retest.
Table 3-73. ATM Board Framer Looparound Test (#1260) — Continued
Error
Code
Te st
Result Description/ Recommendation
Continued on next page