Filter
Top Products
DEFINITY ECS Release 8.2 Maintenance for R8.2csi
555-233-119 Issue 1
April 2000
Maintenance Commands
2-197reset io-processor
2
reset io-processor
This command resets and initializes the IO-Processor hardware and firmware.
The IO-Processor supports the packet interface and Data Channel data
scanners. The IO-Processor is simply reset. Failure of the reset can lead to the
processor being placed in the out-of-service state.
!
CAUTION:
Resetting the IO-Processor (which also resets the packet interface and
Data Channel data scanner) is disruptive. ISDN call service throughout the
system is disrupted, and some data may be lost on Data Channel
communications during the reset interval.
reset interface
This command resets the Processor Interface circuit pack, reads its associated
software from tape, restarts applications processes, re-establishes permanent
switched calls, and sets up each enabled link. If the interface cannot be
established, a Major alarm raises on the interface and all enabled links
deactivate. When the Message Server Adjunct (MSA), Distributed
Communications System (DCS), Audio Information Exchange (AUDIX), or Call
Management System (CMS) are initially administered, links for these applications
and submitting the form restarts the interface. Before Processor Interface circuit
packs are replaced, technicians must power down the switch and restart it.
Alt. Name
Alternate way to identify maintenance objects.
If the Object is The field contains
station extension
trunk
xxx/yyy
(where
xxx
= trunk group number
and
yyy
= member number)
private CO line
P/xxx
(where
xxx
= private CO line group number)
Result
Success status of a busied out object (PASS, ABORT, FAIL)
Error Code
System-generated description of a command failure.
Action/Object Qualifier Qualifier Description Permissions Defaults
Feature
Interactions
reset
io-processor
none none init
inads
craft
nms
none