Filter
Top Products
DEFINITY ECS Release 8.2 Maintenance for R8.2csi
555-233-119 Issue 1
April 2000
Maintenance Commands
2-174netstat ip-route
2
Field descriptions
netstat ip-route
This command displays the routing tables that are resident in the C-LAN circuit
pack. With the “board” option, the command
netstat ip-route board UUCss
displays the routing tables that are resident on the specified C-LAN circuit pack.
Output
The following example shows the output from the
netstat ip-route
command.
Trunk
Group/Member
Trunk group and group member number. (1-99/1-99).
Port
The port location (cabinet-carrier-slot-circuit) for trunks.
Signaling Group
ID
If the trunk is ISDN, this field contains the number of the ISDN
Signaling Group. Otherwise, this field is blank. ( )
Connected Ports
Port locations (cabinet-carrier-slot-circuit) connected to the trunk.
Service State
In-service/active, in-service/idle, out-of-service, out-of-service-NE
(Near End), out-of-service-FE (Far End), maint-NE/active,
maint-FE/active, maint-NE/idle, maint-FE/idle, pending-in-service,
pending-maint, or disconnected. NE (Near End) and FE (Far End)
refer to the “end” of the trunk that has placed the facility in its current
state.
Maintenance
Busy
This field identifies maintenance testing that occurs on the trunk.
CA-TSC State
The state of temporary signaling connections. (connection set up to
pass call information over PRI signaling links).
Action/ Object Qualifier Qualifier Description Permissions Defaults
Feature
Interactions
netstat ip-route
board
UUCss
Example:
netstat ip-route board 01A03
init
inads
craft
none none
netstat ip-route page 1 of xxx
IP ROUTING - C-LAN
Destination Gateway C-LAN Bd/Pt Interface
1:___.___.___.___ ___.___.___.___ 01C0514 ppp13
2:___.___.___.___ ___.___.___.___ 01C0517 cmp0
3:___.___.___.___ ___.___.___.___ 01C0518 lo03