Lucent Technologies 555-233-119 Home Theater Server User Manual


  Open as PDF
of 1872
 
DEFINITY ECS Release 8.2 Maintenance for R8.2csi
555-233-119 Issue 1
April 2000
Maintenance Objects
3-810MEDPROPT (TN802 MED PRO DSP PORT)
3
Table 3-352. TDM NIC Looparound Test (#1380)
Error
Code
Te st
Result Description/ Recommendation
1002 ABORT The system could not allocate timeslots for the test. The system may be
under heavy traffic conditions or it may have timeslots out of service due to
TDM-BUS errors.
1. If system has no TDM-BUS errors and is not handling heavy traffic, retry
the command at 1-minute intervals a maximum of 3 times.
2. If system has TDM-BUS errors, clear any errors, and retry the command
at 1-minute intervals a maximum of 3 times.
3. If the command continues to abort, escalate the problem.
1003 ABORT The system could not allocate a tone receiver for the test. The system may
be oversized for the number of Tone Detectors present or some Tone
Detectors may be out of service.
1. Resolve any TTR-LEV errors. Even if there are no TTR-LEV errors, there
may not be a Tone Detector available on the network that contains the
circuit pack being tested. Verify that there is at least one Tone Detector
on this network. This does not harm the system.
2. Resolve any TONE-PT errors.
3. If neither condition exists, retry the command at 1-minute intervals a
maximum of 3 times.
2000 ABORT Response to the test was not received in the allowable time period.
1. Retry the command at 1-minute intervals a maximum of 3 times.
2100 ABORT Could not allocate the necessary system resources to run this test.
2500 ABORT Internal system error.
1. Retry the command at 1-minute intervals a maximum of 3 times.
2801 ABORT The TN802B Media Processor board has not been administered on the
ip-interfaces form.
ANY FAIL The test did not detect the test tone through the looparound connection.
1. Test the tone-clock in the port network that contains the media processor
under test.
2. If the tone-clock is healthy, test the media processor board again.
3. If the test continues to fail, replace the media processor board.
PASS The board is functioning properly.
Continued on next page