Filter
Top Products
DEFINITY ECS Release 8.2 Maintenance for R8.2csi
555-233-119 Issue 1
April 2000
Maintenance Objects
3-190ATM-NTWK (ATM Network Error)
3
ATM-NTWK (ATM Network Error)
In the ATM PNC configuration, the proprietary Center Stage Switch (CSS) is
replaced by the ATM network. Since the CSS switch nodes are replaced by the
ATM network in the ATM PNC configuration, the SNI boards are no longer
needed. In place of SNI board, the ATM EI boards are connected to an ATM
switch port over a fiber optic cable. The port on the ATM switch is under the
control of ATM switch maintenance software. Refer to Figure 1-30
in the ‘‘ATM
Tips’’ section in Chapter 1 for a schematic of these connections.
An error against this MO indicates a problem in the ATM network (including the
ATM switch) that is affecting the service quality. These error events are reported
by the ATM network to the ATM EI board or are detected by the ATM EI board.
Since these errors are
not
related to the ATM EI board, these errors are not
reported against the ATM-EI Maintenance Object. However, some of these errors
invoke alarms that require action by DEFINITY maintenance, while other log-only
errors require no action.
Error Codes and Aux Data values
The Cause Code/Error Type information is shown inTable 3-81. These are the
possible errors that can be logged against the ATM-NTWK MO.
If the ATM-NTWK Maintenance Object receives more than 6 errors, the most
recent errors are discarded.
MO Name
(in Alarm
Log)
Physical Name in
Error Logs
1
1. AT indicates it is an ATM switch related address, UU is the connection number. The
connection number can be converted into a board location by the command display atm
pnc UU, which shows the translations for the board that reported the ATM network error. P
indicates if the ATM-EI board (reporting the ATM network error) is the A side or the B side
of the PNC. If the system is simplex, only A is valid.
Alarm Level Full Name of MO
ATM-NTWK ATUUP WARNING ATM Network Error