Filter
Top Products
DEFINITY ECS Release 8.2 Maintenance for R8.2csi
555-233-119 Issue 1
April 2000
Maintenance Commands
2-243status conference
2
Meet-me
number
The Meet-Me Number administered for the Meet-Me Extension. ( )
Dial Type
“in” = dial-in to join endpoint to conference.
“out” = dial-out to join endpoint to conference.
In Use
“y”
=
the endpoint is in use and is fully-connected on all media in an
active conference.
“c” = the endpoint is in use and is fully-connected; however, the
endpoint has changed conference audio or video capability or
conference rate due to rate adaptation. This condition requires
analysis of this endpoint’s capabilities and mode fields to identify
reduced capability.
“e” = the endpoint is in use but has capability problems. The endpoint
lacks one of the required capabilities (Vid, Bhl, MLP) to fully
participate. For MLP capabilities, see the “T120” field. This condition
requires analysis of this endpoint’s capabilities and mode field to
identify the missing capability.
“f” = the endpoint is in use but not connected to all media. The
endpoint declared all required capabilities (channel/video/
audio/data) but is not fully connected to all conference media. This
endpoint may be connecting, failed to connect, or is not a valid video
source. This condition requires analysis of this endpoint’s capabilities
and mode fields to identify the problem.
“n” = the endpoint disconnected during a conference or
unsuccessfully attempted to connect to a conference.
“blank” = the field is blank until the first call from or to the endpoint.
Chl
“y” = the endpoint has the required number of channels.
“e” = the endpoint does not declare support for the correct number of
channels and cannot participate fully in the conference.
“n” = the endpoint declares the correct number of channels, but not
all join the conference, due to a network or endpoint problem.
“blank” = Audio add-on endpoints set the
Chl
field to blank.