Filter
Top Products
DEFINITY ECS Release 8.2 Maintenance for R8.2csi
555-233-119 Issue 1
April 2000
Maintenance Objects
3-655ETR-PT (Enhanced Tone Receiver Port)
3
ETR-PT (Enhanced Tone Receiver Port)
NOTE:
Replacing the tone/clock circuit pack requires a special procedure which is
described in the documentation for TONE-BD. This section also describes
the LED display for this board.
The TN2182 is a combined Tone Generator/Tone Detector board, providing 8
Enhanced Tone receiver (ETR) ports. Each of these ports provides the functions
previously found individually on DTMR-PTs, GPTD-PTs and CLAS-PTs ports.
Thus, each port on the TN2182 can be used for any tone detection function that
was previously done by TN748, TN420 or TN744 Tone detection boards.
The TN2182 provides mu-law or A-law tone detection capability.
Since the TN2182 also provides Tone/Clock function, the TN2182 circuit pack is
the only Tone board allowable in the CMC.
Hardware Error Log Entries and Test to Clear
Valu es
MO Name (in
Alarm Log)
Alarm
Level Initial Command to Run
1
1. P is the port network number (1 for PPN). C is the carrier designation (A, B, or C). SS is the
number of the slot in which the circuit pack resides (01 to 21).
Full Name of MO
ETR-PT(a) MAJOR test port PCSSpp sh Enhanced Tone Receiver Port
ETR-PT MINOR test port PCSSpp sh Enhanced Tone Receiver Port
ETR-PT WARNING test port PCSSpp sh Enhanced Tone Receiver Port
Table 3-272. Enhanced Tone Receiver Port (ETR-PT) Error Log Entries
Error
Type
Aux
Data Associated Test
Alarm
Level
On/Off
Board Test to Clear Value
1 any Tone Detector
Audit/Update Test
(#43)
MAJOR/
MINOR (a)
ON test port PCSSpp r 2
18 busyout port WARNING OFF release port
PCSSpp
257 (b) 17666 Tone Detection Audit
Update Test (#43)
MAJOR/
MINOR (a)
ON test port PCSSpp r 3
Continued on next page