Filter
Top Products
DEFINITY ECS Release 8.2 Maintenance for R8.2csi
555-233-119 Issue 1
April 2000
Maintenance Objects
3-181ATM-EI (Expansion Interface Circuit Pack)
3
1015 ABORT This test cannot be run because the ATM-TRK circuit pack has not been
busied out.
1. Busyout the ATM circuit pack, then repeat the test board UUCSS
long command.
1407 ABORT 1. Perform a PNC Interchange
2. Try to reset the board again.
None ABORT Could not allocate the necessary system resources to run this test.
1. Retry the command at 1-minute intervals a maximum of 5 times.
2. If the test continues to abort escalate the problem.
2000 ABORT Did not receive the SANITY response in the given time.
1. Wait for 5 minutes and see if board is visible to the system by using
list config all command.
2. If the board is visible, run the test again. If same abort code results,
escalate the problem.
3. If the board is not visible to the system via list config all command,
re-seat the board.
4. If the board is still not recognized by the system, replace the board.
2100 ABORT Could not allocate the necessary system resources to run this test.
1. Retry the command at 1-minute intervals a maximum of 5 times.
2500 ABORT Internal system error
1. Try to reset the board again.
1
2
FAIL
FAIL
The circuit pack failed to reset
The circuit pack failed to restart.
1. Execute command again.
2. If the problem persists, replace the circuit pack.
PASS The ATM-EI circuit pack is successfully reset.
1. If the status port-network command still indicates that this link is
down, it is possible that one or both of the ATM-EI circuit packs are
busied out.
2. If the links do not come up after reset, review the error logs and take
appropriate diagnostic action.
Table 3-75. ATM Board Reset (#1256) — Continued
Error
Code
Test
Result Description/ Recommendation
Continued on next page