Filter
Top Products
DEFINITY ECS Release 8.2 Maintenance for R8.2csi
555-233-119 Issue 1
April 2000
Maintenance Objects
3-321CABINET (Cabinet Sensors)
3
This means that a failure of this test can also mean a power problem, not
necessarily just a temperature (fan) problem. Also, alarm leads from multiple
cabinets are tied into one single lead.
Table 3-140. TEST #122 Cabinet Temperature Query Test
Error
Code
Te s t
Result Description/ Recommendation
1000 ABORT System resources required to run this test are not available.
1. Retry the command at 1-minute intervals a maximum of 5 times.
2000 ABORT Response to the test request was not received within the allowable time
period.
2029 ABORT Internal system error
1. Retry the command at 1-minute intervals a maximum of 5 times.
1 FAIL There is a fan and/or power problem in one or more of the cabinets. The
LEDs on the power supply may indicate the problem source. Otherwise
follow the procedures below for each cabinet:
1. If none of the fans are running, then:
a. Verify 8-14 volt DC power is available to the fan units by checking
the wiring connector.
— If there is 8-14 volt DC power at the connector, there should be
power to the fans. If the fans still do not run, replace the fan
assembly.
— If there is no 8-14 volt DC power at the connector, then the
power unit fan output is defective or thermally shut down. Let
the power unit cool and recycle AC input power. If not fan
output, then replace the power unit. If the fans still do not run,
escalate the problem.
2. If only 1 of the fans is not running, replace the fan.
3. If all the fans can be started, wait five minutes and rerun the test. If the
test fails again, proceed to Step 4 or 5 as applicable.
Continued on next page