Filter
Top Products
DEFINITY ECS Release 8.2 Maintenance for R8.2csi
555-233-119 Issue 1
April 2000
Maintenance for csi systems
1-26Logging On/Off
1
Logging On/Off
System Login Procedure
1. Verify the screen displays:
Login:
2. Type
craft
and press
Enter.
3. Verify the screen displays:
password
:
4. Type
crftpw
and press
Enter. For security reasons, the password is not
displayed as it is typed. The screen displays the software version.
5. Verify the screen display is similar to:
Terminal Type (513, 715, 4410, 4425, VT220): [513]
6. Enter the type of management terminal and press
Enter.
NOTE:
If you are logging in remotely to the csi, you may need to disable your local
modem’s error correction feature before attempting to establish connection
with the switch’s external modem. For most modems, the
AT\N0
[“zero”]
command should disable error correction.
Forced Password Aging and Administrable
Logins
This feature provides enhanced login/password security by adding a security
feature that allows users to define their own logins/passwords and to specify a
set of commands for each login. The system allows up to 11 customer logins.
Each login name can be customized and must be made up of from 3 to 6
alphabetic/numeric characters, or a combination of both. A password must be
from 4 to 11 characters in length and contain at least 1 alphabetic and 1 numeric
symbol. Password aging is an optional feature that the super-user administering
the logins can activate.
NOTE:
If several users are logging in and out at the same time, a user may see the
message:
Transient command conflict detected; please try
later
. After the “users” have completed logging in or out, the terminal is
available for use.
The password for each login can be aged starting with the date the password
was created, or changed, and continuing for a specified number of days (1 to
99). The user is notified at the login prompt, 7 days before the password
expiration date, that the password is about to expire. When the password expires
the user is required to enter a new password into the system before logging in. If
a login is added or removed, the “Security Measurement” reports are not