Filter
Top Products
DEFINITY ECS Release 8.2 Maintenance for R8.2csi
555-233-119 Issue 1
April 2000
Maintenance Commands
2-199reset system
2
reset system
This command resets the system beginning with the corresponding vector bit
set, a core dump is written to memory card, only if the memory card is the special
core dump card), the vector is cleared, and the requested restart is performed.
NOTE:
All successful reset system commands log users off.
Feature Interactions
■ The
reset command
invokes system initialization like low-level
maintenance. Software never escalates requested reset levels;
technicians determine the levels.
■ Two hardware switches are associated with active SPEs. These hardware
switches override demand maintenance activities requested by system
technicians.
reset translation-id
This command resets the translation-ID on the translation card(s) to match the
processor(s), saves translations to the memory card, and restores use of the add,
change, remove, and duplicate commands.
NOTE:
This command can be executed only by Lucent Services.
Action/Object Qualifier Qualifier Description
1
1 Descriptions of all reset levels are in the ‘‘Initialization and Recovery’’ section of Chapter 1,
‘‘Maintenance for csi systems’’.
Permissions Defaults
Feature
Interactions
reset system
level
1 = Warm Restart
2 = Cold 2
3 = Cold1
4 = Reboot
init
inads
craft
none see below
Action/Object Qualifier Qualifier Description Permissions Defaults
Feature
Interactions
reset
translation-id
Example:
reset translation-id
Lucent
Services
only
See
‘‘Error
message’’