Filter
Top Products
DEFINITY ECS Release 8.2 Maintenance for R8.2csi
555-233-119 Issue 1
April 2000
Maintenance Commands
2-33change system-parameters maintenance
2
SPE Optional Boards
Packet Intfl?
These fields indicate if a Disk circuit pack is present, and identify
administered Packet Interface slots. If a Packet Interface circuit
pack is present, the corresponding Packet Interface field is set to
y
when the system boots. No change to that field is allowed. If the
system is equipped with duplicated SPEs, the
Packet
Interface
field is set to
y
if either SPE carrier contains a Packet
Interface circuit pack in the corresponding position. If a Packet
Interface circuit pack is not present, the value for the
Packet
Interface
field is read from translation data, and stored on disk
or tape. If the field is set to
n
, a Packet Interface circuit pack may
be administered by changing the corresponding
Packet
Interface
field to
y
.
This field identifies the presence of
Packet Interface 1
(always set to
y
for csi and si models).
Packet Intf2?
This field identifies the presence of
Packet Interface 2
(always set to
y
for the si model). It is changeable for the csi
model. If set to
y
for the csi model, the
Bus Bridge
and
Inter-Board Link Timeslots
fields display. Default is
n
.
Packet Intf3?
This field identifies the presence of
Packet Interface 3
(Unavailable in the si and csi models). It is changeable in the r
model. Default is
n
.
Bus Bridge
(If
Packet Intf2
set to
y
) This field gives the location of the
C-LAN circuit pack performing the bus bridge functionality when
the packet bus is activated. Enter the 5-character circuit pack
number (CCcss, where CC = cabinet number 1-3, c = carrier
A-E, ss = slot number 0-20). Default is blank.
Inter-Board Link
Timeslot Pt0
The number of timeslots to be used for port 0 on the Inter-Board
Link. Displays only if the switch model type is csi and the
Packet
Intf2
field is
y
. Enter the number of timeslots (
1
-
9
) to be used by
this Inter-Board Link port. Default is
6
.
Inter-Board Link
Timeslot Pt1
The number of timeslots to be used for port 1 on the Inter-Board
Link. Displays only if switch model type is csi and the
Packet
Intf2
field is
y
. Enter the number of timeslots (
1
-
3
) to be used by
this Inter-Board Link port. Default is
1
.
Inter-Board Link
Timeslot Pt2
The number of timeslots to be used for port 2 on the Inter-Board
Link. Displays only if switch model type is csi and the
Packet
Intf2
field is
y
. Enter the number of timeslots (
1
-
3
) to be used by
this Inter-Board Link port. Default is
1
.