Filter
Top Products
DEFINITY ECS Release 8.2 Maintenance for R8.2csi
555-233-119 Issue 1
April 2000
Maintenance Commands
2-273status conference
2
Connection
State
The call state of the AC. The following are connection states
associated with dial-out ACs:
“enabled” = Transient in nature indicating that an AC is about to
enter the “attempting to connect” state.
“disabled” = one of three options:
■ The AC reaches an administered retry threshold, and all retries
are stopped. To verify this, check the Error Log to see if an error
type of
9
is logged against the AC.
■ The AC is in a connected state with the far end disconnected.
■ The initial channel call is not connected. No dial out call attempt
is made for the additional channels until the initial channel has
reaches a connected state.
“not scheduled” = Transient in nature, indicating that an AC is about
to enter the “attempting to connect” state.
“waiting to retry” = The AC is inactive, waiting for the retry timer to
expire. Once the timer expires, the AC sends a dial out call and
enters the “attempting to connect” state. In this state, dial out calls
fail at least once.
“attempting to connect” = The AC is active, but has not connected.
“connected” = The call associated with the AC is answered and joins
cut-thru to the conference.
Retry Count
Tallies the attempted retries for this AC during join attempts and does
not clear when the AC connects. However, it clears when the Redial
feature attempts a new join. This differs from the
Join Count
which
counts the number of times the channel joins the conference during
this conference session.
Failure Cause
An ISDN or CPTR cause value (values lower than 0x7f) records when
the last dial out call drops. Values above 0x7f are generated
internally.
Table 2-6
lists all possible failure cause values displayed
by this field and its associated description. The
Failure Cause
value logs in the Error Log and displays with the
display errors
command. (
Err Type
is normally displayed as a decimal.)
Table 2-6. Status AC - Failure Cause Values
Failure Cause
(hexadecimal) Description
0x00 (0t0) N/A
0x01 (0t1) Incorrect destination address
0x02 (0t2) Reason unknown
Continued on next page