Filter
Top Products
DEFINITY ECS Release 8.2 Maintenance for R8.2csi
555-233-119 Issue 1
April 2000
Maintenance Commands
2-249status conference
2
Drop Reason
(cont’d)
Endpoint
Clearing received from DS1. The endpoint causes the
disconnect. The endpoint notifies the MCU that it intends to disconnect.
Far-end Clearing received from DS1. The network or endpoint cause the
disconnect.
“Handshake” = Framing is not located or is lost for over 40 seconds and
the endpoint disconnects. (The endpoint cannot complete initialization
due to problems with finding Frame Alignment Signal (FAS), Multi Frame
Alignment (MFA) and getting a corrected coded cap-set.)
“IDtimeout” = The H.320 sends three unsuccessful responses to the
MCU regarding the UIN/password Query. Timeout periods exist for each
period.
“Internal” = MCU cannot allocate the necessary trunk resources to route
the dial-out call for the specified dial-numbers. This problem can be
associated with routing patterns or trunk associated translations, or it
can indicate insufficient trunk resources.
“Network” = Clearing received from DS1. The network causes the
disconnect. The endpoint with disconnect notification capability
disconnects without notifying the MCU.
“Not-MCU” = The dial-out destination number(s) of the “CAS” extension
terminates to a number that is not a dial-in cascade MCU extension.
“No-ring” = Calls are up for 30 seconds without ringing.
“Reorder” = The MCU CPTR resources detects that no network trunks
are available to place the call. See “Dial-out” for a description of CPTR
usage.