Filter
Top Products
DEFINITY ECS Release 8.2 Maintenance for R8.2csi
555-233-119 Issue 1
April 2000
Maintenance Commands
2-308status trunk
2
SPE Modes
status trunk
This command displays internal software state information for diagnosis and can
help locate facilities to which the trunk is communicating. If a trunk group number
is entered without a member number, a list showing the status for each member
in the specified group displays. If a both the trunk group and member numbers
are entered, the status for only the specified member displays.
Simplex SPE Modes
active
1A
SPE in a simplex system is always the active SPE
blank
No 1B SPE in a simplex system
Busyout Modes
busyout/idle
SPE busied out and there is no current maintenance activity.
The active SPE can be either active or selected.
busyout/entering
SPE busied out and in the process of restarting the switch
software on this SPE. After the switch software finishes its
initialization, the standby SPE is available for maintenance
functions on the standby SPE.
busyout/testing
SPE busied out, however, the switch software on this SPE has
been restarted and is currently in the process of executing a
test
command.
busyout/
not-refreshed
SPE busied out, however, the
busyout spe-standby
command was executed at a time when the standby memory
was not refreshed. The standby SPE is not able to perform any
maintenance or SAT-requested activities until a successful
refresh spe-standby
command is executed.
busyout/
list-config
SPE busied out, however, the switch software on this SPE has
been restarted and is currently executing a
list configuration
command.
busyout/status
SPE busied out, however, the switch software on this SPE has
been restarted and is currently in the process of executing a
status card-mem
command.