Filter
Top Products
DEFINITY ECS Release 8.2 Maintenance for R8.2csi
555-233-119 Issue 1
April 2000
Maintenance Objects
3-118ANN-PT (Announcement Port)
3
Notes:
a. The Announcement circuit pack can exhibit a condition that does not allow
recording.
If the circuit pack gets locked into this state (this is an extremely rare
condition), two of the Announcement Ports on the circuit pack (one of
which is the record port) will be unusable by software. Also,
save/restore
1 to 254 FAIL Test failed. The error code indicates the number of byte count errors found
by the Tone Detector.
1. Reset the circuit pack via the reset board PCSS command and then
run this test again. If the test continues to fail, replace the circuit pack
(see Warning).
2. If there are recurring alarms on this port caused by this test failing,
replace the circuit pack even if Step 1 works (see Warning).
!
WARNING:
Replacing the circuit pack results in loss of integrated
announcements. Refer to ‘‘General Notes’’
near the beginning of this
Maintenance procedure.
255 FAIL Test failed. The Announcement Port and the Tone Detector never
synchronized. Check for active GPTD-PT errors, and refer to "GPTD-PT
[General Purpose Tone Detector Port (CPTR)]" Maintenance
documentation to diagnose them first.
1. If there are no active GPTD-PT errors, reset the circuit pack via the
reset board PCSS command and then run this test again. If the test
continues to fail, replace the circuit pack (see Warning).
2. If there are recurring alarms on this port caused by this test failing,
replace the circuit pack even if Step 1 works (see Warning).
!
WARNING:
Replacing the circuit pack results in loss of integrated
announcements. Refer to ‘‘General Notes’’
near the beginning of this
Maintenance procedure.
PASS This port can cleanly play announcements. User-reported troubles on this
pack should be investigated using other port and circuit pack tests. Refer
to ‘‘ANN-BD (Announcement Circuit Pack)’’ Maintenance documentation
for a description of the circuit pack tests.
Table 3-45. TEST #206 Playback Speech Memory Array (PSMA) Test — Continued
Error
Code
Te s t
Result Description/ Recommendation
Continued on next page