Filter
Top Products
DEFINITY ECS Release 8.2 Maintenance for R8.2csi
555-233-119 Issue 1
April 2000
Maintenance Commands
2-292status pri-endpoint
2
Field Description
status pri-endpoint
This command displays internal software state information for diagnosis and can
help locate facilities with which a PRI endpoint is communicating. Status
information for each of the B-channels making up the PRI endpoint display in
addition to some overall PRI endpoint information.
Output
The following example shows the output for the status pri-endpoint 22501
command and assumes the following:
■ PRI endpoint ports for extension 22501 are in cabinet 1, carrier B, slot 20,
circuit 1 to 6.
■ The ports 1 to 3 of the specified PRI endpoint are connected on an active
call to ports 13 to 15 of board in location 1B19 (cabinet 1, carrier B, slot
19).
■ Ports 4 and 5 of the specified PRI endpoint are idle.
Physical Link
State
Up, down, or extension not administered displays. The PMS link is
considered administered only if an extension is given in the
System Hospitality form.
Protocol State
"up", "down", or blank if not administered.
Number of Retries
Number of times the switch has tried to set up the link. Displays
when the link is down. (1–999)
Maintenance Busy
"yes", or "no" (that is, system technician has or has not busied out
the link). Blank if PMS link not administered.
Action/
Object Qualifier Qualifier Description Permissions Defaults
Feature
Interactions
status
pri-endpoint
extension
print
PRI endpoint extension to be
displayed (see dial-plan).
Report sent to printer
Examples:
status pri-endpoint 25012
status pri-endpoint 77868
status pri-endpoint 66078 print
init
inads
craft
nms
browse
none none