Filter
Top Products
DEFINITY ECS Release 8.2 Maintenance for R8.2csi
555-233-119 Issue 1
April 2000
Maintenance Objects
3-171ATM-EI (Expansion Interface Circuit Pack)
3
ATM Board Error Query Test (#1259)
This test is non-destructive. The ATM circuit pack firmware maintains counters for
some of the on-board and off-board errors. The maintenance software queries
the board for its health information to do error analysis. These alarms have
assigned priority: if a higher priority alarm occurs, the remaining alarms are not
reported to the software (through the inline errors), avoiding unnecessary up-link,
in-line error message traffic. This is run as a part of a craft demand test sequence
periodic testing, initialization, and error analysis.
Table 3-70. Packet Interface Test (#598)
Error
Code
Te st
Result Description/ Recommendation
2000 ABORT Response to the test request was not received within the allowable time
period.
1. Retry the command at 1-minute intervals for a maximum of 3 retries.
2. If the test fails repeatedly, attempt to reset the circuit pack.
3. If the test continues to fail, replace the circuit pack.
2012 ABORT Internal system error
2100 ABORT Could not allocate the necessary system resources to run this test.
1. Retry the command at 1-minute intervals a maximum of 5 times.
ANY FAIL The transmitted data packet was not received correctly by the Packet
Interface circuit pack. The failure may be in the ATM-EI under test, the
DS1 CONV circuit packs, or the intervening Center Stage components.
1. Retry the command at 1-minute intervals a maximum of five times
2. If the test continues to fail, replace the circuit pack.
PASS The Packet Interface Test passed.
Continued on next page