Filter
Top Products
DEFINITY ECS Release 8.2 Maintenance for R8.2csi
555-233-119 Issue 1
April 2000
Maintenance Commands
2-204save translation
2
inconsistent due to hardware failures that occur during the
save
announcements
command, error messages display indicating corrective
action. Maintenance software that monitors hardware logs hardware errors
to maintenance. Then, maintenance software invokes tests to diagnose
and attempt corrective action. If maintenance software fails to correct the
problem, an alarm raises displaying corrective action.
■ The
save announcements
command writes two time-stamped, identical
copies of announcement data to selected devices. The time-stamp for
both copies is the same. Each copy contains a timestamp and the state of
the copy. (good or bad)
■ If good copies of announcement files are not available, the restore
announcements command cannot execute until the
save
announcements
command completes. Announcements on the board are
still usable.
Output
The following example shows the output from the
save announcements
command.
Field descriptions
save translation
All translation data is kept in memory during system operation, and if the switch
goes down, the system loses all data. This command allows users to save the
in-memory translation data to the memory card. This command runs as part of
scheduled maintenance and/or on demand by the technician.
Processor
Displays processors when announcement data writes
to its devices. (SPE-A and SPE-B)
Command Completion Status
Whether the command succeeded or aborted.
Error Code
0 = save was successful
1 = unable to save to the active spe device
2 = unable to save to the standby spe device
save announcements Page 1 of 1 SPE A
SAVE ANNOUNCEMENTS
Processor Command Completion Status Error Code
SPE-A Success 0