Filter
Top Products
DEFINITY ECS Release 8.2 Maintenance for R8.2csi
555-233-119 Issue 1
April 2000
Maintenance Objects
3-796MEDPRO (Media Processor MAPD Circuit Pack)
3
To be fully administered, a MedPro circuit pack must meet
all of these 4
conditions
:
1. Have an entry in the circuit pack form (
change circuit pack
)
2. Have the MedPro ip address administered (
change node-names
)
3. Be enabled (
change ip-interface
)
4. Be physically inserted into the correct slot
If the circuit pack has an entry in the circuit packform and either of the
other two conditions are
not
met, a MINOR alarm is logged. To resolve the
error either
1. Make sure all conditions for administration are met and that a
functioning MedPro circuit pack is inserted in the correct slot
OR
2. Completely remove the MedPro from the system using the following
steps:
a. Remove the administered
IP-Interface associated with the
circuit pack.
b. Physically remove the circuit pack from the slot.
c. Execute the
remove medpro UUCSS
and
change circuit
pack UUCSS
commands.
b.
ErrorType 18
-The MedPro Interface circuit pack has been busied out by
a
busyout board UUCSS
command.
1. Release the circuit pack (
release board UUCSS
).
c.
Error Type 23
-The MedPro circuit pack is not completely administered.
To be fully administered, a MedPro circuit pack must meet
all of these 4
conditions
:
1. Have an entry in the circuit plan (
change circuit pack
)
2. Have the MedPro IP address administered (
change node-names
)
3. Be enabled (
change ip-interface
)
4. Be physically inserted into the correct slot.
A DS1 (MEDPRO, MAPD, UDS1-BD and DS1-BD) differs from most circuit
packs in that inserting the circuit pack into the switch is not enough to
make the board usable. It must also be administered.
d.
Error Type 125
- no Aux Data: The wrong circuit pack is inserted in the
slot where this circuit pack is logically administered.
1. Remove the wrong circuit pack and insert the logically
administered circuit pack
OR