Filter
Top Products
DEFINITY ECS Release 8.2 Maintenance for R8.2csi
555-233-119 Issue 1
April 2000
Maintenance Commands
2-342test hardware-group
2
Feature Interactions
test
hardware-group
Only one
test hardware-group
command can be active at any
given time.
TTI If the
test hardware-group
command is issued with the
all-ports
option when the TTI background task is active, some
unadministered ports may not be tested. In addition, active alarms
on line ports may be cleared by this task. The
status tti
command
can be used to determine the state of the TTI background task.
Add Station If a
add station
command is entered for an untranslated port at the
same time as it is being tested as part of the
test hardware-group
command with the
all-ports
option, the error message, Object in
use; please try later
displays, and the request fails.
Trunk
administration
If an attempt is made to add an unadministered trunk port to a trunk
group at the same time as it is being tested as part of the
test
hardware-group
with the
all-ports
option, the error message,
Object in use; please try later displays, and the request fails.
Save translation If the
test hardware-group
with the
all-ports
option while a
translation save
operation is active, some unadministered ports
may not be tested. All other hardware will be tested normally.
Hardware alarms When a hardware error is detected by the
test hardware-group
command, the hardware goes through the standard escalation
strategy. Alarms are raised on hardware that manifest ’hard’ errors.
This alarming strategy is the same, regardless of whether the ports
are translated or not.
System interaction The performance of
test hardware-group
is affected by call
processing traffic, administration activity, choice of the
short
or
long
option, whether the
all-ports
option is chosen, whether the
spe-interchange
option is chosen, and other demand maintenance
activity.
Scheduled and
periodic
maintenance
While executing the
test hardware-group
command, all scheduled
background maintenance, periodic background maintenance, and
data audits activity is suspended until the command completes.
When the
test hardware-group
command is canceled or
completes, all suspended periodic, scheduled, and data audits
background maintenance activity will be restarted where it left off.