DEFINITY ECS Release 8.2 Maintenance for R8.2csi
555-233-119 Issue 1
April 2000
Maintenance for csi systems
1-49Troubleshooting Features
1
pressed while on a trunk call. Use of this feature is denied if there are more than
two trunks on a call. If the call is trunk-to-trunk, the identification displayed is of
the last trunk added to the call.
Facility Test Calls
The Facility Test Calls feature provides a voice terminal user the capability of
placing test calls to access specific trunks, touch-tone (DTMF) receivers, time
slots, and system tones. The test call can be made by a local voice terminal user
by dialing an access code.
NOTE:
For the ISDN-PRI Test Call feature, see
‘‘Troubleshooting the Outgoing
ISDN-Testcall Command’’ later in this chapter.
The following Facility Test Calls are described below:
■ ‘‘Trunk Test Call’’
■ ‘‘Touch-tone (DTMF) Receiver Test Call’’
■ ‘‘Time Slot Test Call’’
■ ‘‘System Tone Test Call’’
Trunk Test Call
The trunk test call accesses specific Tie or CO trunks. DID trunks cannot be
accessed.
To place a call:
1. Dial the Facility Test Call Feature Access Code (for example, 197, see
Note), and listen for dial tone.
NOTE:
The Facility Test Call Access Code (FAC) is administered on the
Feature Access Codes Form. The 197 FAC code used here is an
example.
2. Dial the 6-digit port number
PCSSpp
The channels on a DS1 trunk are addressed by using the channel number
for the port number.
P = Port network number (1)
C = Carrier number (A=1, B=2, C=3)
SS = Slot number (01-10)
pp = Port number