DEFINITY ECS Release 8.2 Maintenance for R8.2csi
555-233-119 Issue 1
April 2000
Maintenance Commands
2-61display errors
2
Output
The following examples shows the output from the
display disabled-tests
command.
display errors
The
display errors command creates an Alarm Report. The user completes an
option screen to select the parameters for the report.
The system creates the reports from the logs of the maintenance subsystem. The
subsystem monitors the system hardware and logs problems as errors or alarms.
Errors can result from in-line firmware errors, periodic tests, failures detected
while executing a test command, software inconsistency, or a data audit
discrepancy.
System Reboots and the Error Logs
The system saves the alarm and error logs to the memory card if any of the
following events occur:
—The
save translation
command is executed.
— Translations are saved as part of scheduled maintenance.
— A reboot takes place.
— The PPN is about to lose all power after having been on battery backup.
The attempt to save the alarm and error logs may be unsuccessful if the MSS is
not available.
display disabled-tests SPE A
DISABLED TEST INFORMATION
Test Number
710
Command successfully completed