DEFINITY ECS Release 8.2 Maintenance for R8.2csi
555-233-119 Issue 1
April 2000
Maintenance Commands
2-231status bri-port
2
ASAI 0-63 Established blank blank Transitory state for ASAI adjuncts.
ASAI signaling is connects at Layer
2. Layer 3 Restart procedure does
not complete between switch and
adjunct.
1. Check the adjunct by following
the manufacturer’s
recommended repair
procedures.
2. Verify repairs by executing the
status bri-port PCSSpp
command. Determine that the
L2 state of the signaling link is
L3-Established.
BRI 0-126 Established ext blank Normal state for non-MIM initializing,
fixed and automatic TEIBRI
endpoints.
BRI, ASAI 64-126 Established blank blank Transitory state for automatic TEIBRI
endpoints which support MIM
initialization.
1. Verify that SPID administration
on the switch and endpoint are
consistent. Verify the repair by
executing the status bri-port
PCSSpp command. Determine
that the L2 state of the signaling
link is L3-Established.
Otherwise, proceed to Step 2.
2. Try to replace the endpoint.
Verify the repair by executing
the status bri-port PCSSpp
command. Determine that the
L2 state of the signaling link is
L3-Established.
BRI 64-126 L3-Established ext blank Normal state for automatic TEIBRI
endpoints supporting MIM
initialization.
Table 2-3. Status BRI-Port Command Interpretation — Continued
Endpoint
Types
TEI
Range Layer 2 State
Voi ce
Extension
Service
SPID Description / Recommendation
Continued on next page