Filter
Top Products
DEFINITY ECS Release 8.2 Maintenance for R8.2csi
555-233-119 Issue 1
April 2000
Maintenance Objects
3-992S-SYN-PT (Speech Synthesis Port)
3
Speech Synthesis Parameter Update Test (#169)
This test updates the DTMF interdigit time-out parameter used by the Speech
Synthesis circuit pack to be consistent with that specified by the switch
processing element (SPE).
Table 3-439. TEST #168 Speech Synthesis PSS Handshake Test
Error
Code
Te s t
Result Description/ Recommendation
ABORT Could not allocate the necessary system resources to run this test.
1. Retry the command at 1-minute intervals a maximum of 5 times.
1000 ABORT System resources required to run this test are not available. The port may be
busy with a valid call and therefore unavailable for certain tests. You must wait
until the port is idle (yellow LED if off) before retesting.
1. If the port is idle, retry the command at 1-minute intervals a maximum of 5
times.
2000 ABORT Response to the test request was not received within the allowable time period.
2100 ABORT Could not allocate the necessary system resources to run this test.
1. Retry the command at 1-minute intervals a maximum of 5 times.
Any FAIL The on-board microprocessor has timed out while waiting for the PSS controller
to respond or an invalid command has been received by the on-board
microprocessor from the PSS controller. This type of failure may cause features
using the Speech Synthesis Port’s speech services to malfunction.
1. Replace the circuit pack.
PASS The on-board microprocessor/PSS handshake is working correctly.
User-reported troubles should be investigated using other tests and verifying
other ports on this circuit pack are working correctly.
Continued on next page