Filter
Top Products
DEFINITY ECS Release 8.2 Maintenance for R8.2csi
555-233-119 Issue 1
April 2000
Maintenance for csi systems
1-23Initialization and Recovery
1
WRITE BUFFER TEST PASSED
BTO TEST PASSED
TIMER TEST PASSED
RESET 3 (COLD_1)PERFORMED
Reset System 4 (System Reboot)
In this reset Emergency Transfer is invoked. The boot image is already in the
flash ROM memory. The system reboots immediately after the LMM performs a
series of diagnostics on the processor and memory. Translations reload from the
translation card. Depending on the translation, the reloading process takes from
five to 30 seconds. Thereafter, all port circuit packs are reset, and all telephone
sessions drop. Telephones begin to reconnect to the switch within 30 seconds. In
a large system, reconnection of all telephones may take up to five minutes.
Typical displays are:
INVOKING EMERGENCY TRANSFER
INTERNAL REGISTER TEST PASSED
LOCAL BUS TEST PASSED
ROM CHECKSUM TEST PASSED
CONTROL STATUS TEST PASSED
DCACHE TEST PASSED
ICACHE TEST PASSED
WRITE BUFFER TEST PASSED
BTO TEST PASSED
MEM CONFIG TEST PASSED
MEMORY FUNCTIONAL TEST PASSED
MEMORY MODULE A STUCK BIT TEST PASSED
MEMORY MODULE A PARITY TEST PASSED
MEMORY MODULE A BURST TEST PASSED
VIRTUAL MEMORY TEST PASSED
EXCEPTION TEST PASSED
TIMER TEST PASSED
MTP TEST PASSED
SANITY TIMER TEST PASSED
ADDRESS MATCHER TEST PASSED
FLASH TEXT CHECKSUM TEST PASSED
DECOMPRESSING IDATA in_cnt = 550368, out_cnt =
2080768
RAM DATA CHECKSUM TEST PASSED
MILLISEC TIMER TEST PASSED
IOP SHARED RAM TEST PASSED
RESET 4 (REBOOT)PERFORMED