Filter
Top Products
DEFINITY ECS Release 8.2 Maintenance for R8.2csi
555-233-119 Issue 1
April 2000
Maintenance Commands
2-278status hardware-group
2
Output
The following example shows the output from the
status hardware-group
command.
Field descriptions
Hardware Group Command
State:
“active” = testing in progress, “canceled” = testing canceled,
“complete” = command completed; no testing occurring.
Number of MOs Tested:
Number of MOs in the specified group (refer to
test
hardware-group
command) that the
hardware-group
command
tests, including MOs that were tested or aborted due to resource
contention.
Total Number of MOs to be
Tested:
Number of MOs in the group specified in the
test
hardware-group
command.
Percent Complete:
Ratio of the completed MOs to the MOs to test in the command.
Elapsed Test Time:
Tracks completion time for the hardware-group
command. If a
test cancels and then restarts, the time for the cancel period is
excluded. (HH:MM:SS)
Repetition Number
Number of completed iterations that correspond to the ’repeat’ or
’continuously’ option.
Percentage of Tests
Passed:
Percentage of tests that passed.
Percentage of Tests
Failed:
Percentage of tests that failed.
status hardware-group page 1 of 1
HARDWARE GROUP STATUS
Hardware Group Command State: active
Number of MOs Tested: 11070
Total Number of MOs to be Tested: 12300
Percent Complete: 90%
Elapsed Test Time (hr:min:sec): 0:15:30
Repetition Number: 1
Percentage of Tests Passed: 82%
Percentage of Tests Failed: 11%
Percentage of Tests Aborted: 7%
ENTERED HARDWARE GROUP COMMAND
Command: test hardware-group system
Test sequence: short
Test repetition: repeat 3
Output Options: failures
Hardware Options: SPE-interchange