Filter
Top Products
DEFINITY ECS Release 8.2 Maintenance for R8.2csi
555-233-119 Issue 1
April 2000
Maintenance Objects
3-907PKT-INT (Packet Interface)
3
the
out-of-service
state. Therefore, it is expected that the repair procedures
associated with Abort Code 1137 (out-of-service) would normally be followed
when failures with the Level 2 test occurs.
Test #885 executes differently depending on which instance of Packet Interface
is tested:
1. Packet Interface 1 (TDM Bus-based) - No hardware is tested. Only
operational firmware is tested.
2. Packet Interface 2 (Packet Bus-based) - All three tests are executed.
Table 3-389. TEST #885 Private Looparound Tests
Error
Code
Te st
Result Description/ Recommendation
1006
1137
ABORT Packet Interface is in the out-of-service state so normal maintenance tests
will not run on it.
1. Use the
display system-parameters maintenance
command to identify
which C-LAN circuit pack is administered with the Bus Bridge. Verify
that the C-LAN circuit pack is present and is not alarmed.
2. Request a Packet Interface reset using the
reset
packet-interface AS
command. Refer to the Packet Interface
Reset Test (#889) repair procedures for further action.
1334 ABORT The Packet Interface command queue is full. This should be a temporary
condition caused by a high rate of commands being sent to a Packet
Interface. Continued operation with a full command queue will cause a
system WARM restart that may escalate to more severe restart levels.
1. Retry the command at 10-second intervals, a maximum of 5
times.
2000 ABORT Response to the test request was not received within the allowable time
period.
1. Retry the command at 1-minute intervals, a maximum of 3 times.
2500 ABORT Internal system error.
1. Retry the command.
NO
BOARD
The Packet Interface is not detected as being physically present.
1. Reboot the system, then retry the command. If the NO BOARD
indication persists, replace the TN798 Processor circuit pack.
Continued on next page