Filter
Top Products
DEFINITY ECS Release 8.2 Maintenance for R8.2csi
555-233-119 Issue 1
April 2000
Maintenance Objects
3-987S-SYN-PT (Speech Synthesis Port)
3
Speech Synthesis DTMF Receiver Inquiry Test
(#164)
This test determines the sanity of the port’s DTMF receiver. The on-board
microprocessor tests the port’s DTMF receiver and determines if it is in a sane
(test passes) or insane (test fails) condition.
Any FAIL DTMF tones were not detected. This type of failure may cause features
using touch-tone input to the Speech Synthesis Port to malfunction.
1. Verify that the Tone-Clock circuit pack is functioning correctly by
checking the Error Log and using the test tone-clock long command.
2. If the test fails again, replace the Speech Synthesis circuit pack.
PASS The port has detected all DTMF tones correctly. User-reported troubles
should be investigated using other tests and verifying other ports on this
circuit pack are working correctly.
Table 3-435. TEST #164 Speech Synthesis DTMF Receiver Inquiry Test
Error
Code
Te s t
Result Description/ Recommendation
ABORT Could not allocate the necessary system resources to run this test.
1. Retry the command at 1-minute intervals a maximum of 5 times.
1000 ABORT System resources required to run this test are not available. The port may
be busy with a valid call and therefore unavailable for certain tests. You
must wait until the port is idle (yellow LED if off) before retesting.
1. If the port is idle, retry the command at 1-minute intervals a maximum
of 5 times.
2000 ABORT Response to the test request was not received within the allowable time
period.
2100 ABORT Could not allocate the necessary system resources to run this test.
1. Retry the command at 1-minute intervals a maximum of 5 times.
Continued on next page
Table 3-434. TEST #163 Speech Synthesis DTMF Receiver — Continued
Error
Code
Te s t
Result Description/ Recommendation
Continued on next page